橡胶接头在试压的时候要先检查的就是橡胶软接头的型号以及橡胶软接头的规格，只有通过这样才能够计算出橡胶软接头在使用时候的注意事项。 Guide: When testing the rubber joint, the first thing to check is the model of the soft rubber joint and the specifications of the soft rubber joint. Only by doing so can you calculate the precautions for the soft rubber joint when using it.
When testing the rubber joint
, the type of the soft rubber joint and the specifications of the soft rubber joint
must be checked first. Only by this can the precautions for the soft rubber joint be calculated. Since the soft rubber joint is pressure-resistant when it is used, the following methods for testing the rubber soft joint are summarized for you. So what should you pay attention to when testing the soft rubber joint?
In Shanghai rubber flexible joints are installed, the production competition measurement is performed because the types of rubber flexible joints used in different pipeline environments will be different.
Therefore: After the installation of the piping system, the auxiliary positioning mechanism and fasteners used for installation and transportation protection on the soft rubber joint should be removed immediately, and the limit device should be adjusted to the specified position according to the design requirements, so that the piping system can be fully environmentally protected. Compensation.
Except for the design that requires pre-tension or "cold tight" pre-deformation, it is not allowed to use rubber ball joint deformation method to adjust the installation deviation of the pipeline, so as not to affect the normal function of the rubber soft joint, otherwise it will reduce its service life and increase Loads of piping, equipment and support members.
The quality inspection department's main job is water pressure detection. Every day, Shanghai rubber soft joints and rubber soft joint products are tested for water pressure in order to maintain good use.
The detection method is: for example, the Shanghai rubber soft joint and the rubber soft connected rubber pipe body have a pressure of 16kg. At the time of the test, the Shanghai rubber soft joint and the rubber soft connection product detect a 25 kg pressure and then hold the pressure for 10-20 minutes Wait, if there is no water leakage, it is considered a qualified product!
Shanghai Luoying Pipeline Equipment Co., Ltd.
has more than 20 years of production experience. It has strict quality control from the production of rubber joints to finished products. It also uses special rubber to make special rubber joints, regardless of the choice of raw materials. From the manufacturing process of rubber joints, we have unique experience and solutions to ensure the quality of each rubber joint. However, Shanghai Luoying Pipeline Equipment Co., Ltd. has been a professional manufacturer of rubber joints for many years. Our company can process rubber. The types are also diverse, and the quality of our Shanghai Luoying products conforms to national standards. The rubber joint products sold are accompanied by a supply list and quality inspection report and a company quality inspection chapter. Know the specific data of each test, please feel free to use our products. Please contact the hotline at 021-62212627.